On Thu, May 27, 2010 at 01:22:15AM +0900, �ſ��� wrote: > After I posted original thread, I could find the "Port" table has > information about "trunk" > > And the manual(http://openvswitch.org/ovs-vswitchd.conf.db.5.pdf) said, > > A bridge port must be configured for VLANs in one of two mutually exclusive > ways: > 1) A����trunk port���� has an empty value for tag and a possibly non-empty > trunks value. > 2) An ����implicitly tagged VLAN port���� or ����access port���� has an > nonempty value for tag and > an empty trunks value. > If trunks and tag are both nonempty, the configuration is ill-formed > > so, I firstly tried in the way of "1", (set trunks value as 100), servers > and VMs cannot communicate each other, > and when I set trunks value as 0,100 then they communicate each other. > (maybe because of "0")
I would just leave both values empty, to trunk all VLANs. This is normally the desired behavior.
_______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss_openvswitch.org
