On 6/24/22 11:21, dan moylan wrote:
running fc36 on lenevo thinkpad T460 (alphacent), printer hp
photosmart d110.
because of other problems, xfinity just came and provided a
new modem/router/wifi. i logged into xfinity's device and
set up reserved ip addresses for my stuff in accordance with
/etc/hosts:
127.0.0.1 localhost.localdomain localhost
127.0.0.1 alphacent.localdomain alphacent
10.0.0.1 xfinity.localdomain xfinity
10.0.0.63 aldeberon.localdomain aldeberon
10.0.0.62 d110.localdomain d110
10.0.0.61 unknown
10.0.0.60 alphacent.localdomain alphacent
50.87.218.82 bluedan
all is well, except for the printer. i went through the
wireless setup on the printer which declared success, but
the xfinitiy modem shows it as an offline device --
un-pingable.
moylan nmp[1111] nmap -Pn 10.0.0.62 > 3log
Starting Nmap 7.92 ( https://nmap.org ) at 2022-06-24 11:14 EDT
Nmap scan report for d110.localdomain (10.0.0.62)
Host is up (0.10s latency).
All 1000 scanned ports on d110.localdomain (10.0.0.62) are
in ignored states. Not shown: 990 filtered tcp ports
(no-response), 10 filtered tcp ports (host-unreach)
Nmap done: 1 IP address (1 host up) scanned in 7.04 seconds
what's going on?
ole dan
I swapped out my gateway with Comcast last month because of the speed
increases back in March. My HP printer was connected to the previous and
is connected to the new, via Ethernet. The printer apparently retained
its IP address in its settings, so once it was connected to the new
gateway, it just worked.
If the above is the IP address of the printer and HPLIP is already
installed, as superuser/root, running:
hp-setup -a 10.0.0.62
in a terminal window, should otherwise configure it.
_______________________________________________
Discuss mailing list
Discuss@lists.blu.org
http://lists.blu.org/mailman/listinfo/discuss
