anyang, > Hi all, > > I run 3 nodes corosync cluster with cman, and above it run qpidd cluster mode > service. > All the packages is from CentOS 6.5 repo and MRG clone repo, > http://glitesoft.cern.ch/cern/mrg/slc6X/x86_64/RPMS/. > > I test the cluster system with qpid-send and qpid-receive tools, the max > bandwidth is about 117-119MB/s. > > When I run standalone qpid performance test, the bandwidth will reach more > than 9Gb/s, so I think the operating system and hardware tuning is good. > > Corosync' s totem protocol has many options, maybe the default > configuration is suit for Gbe network, could you give any advices, let > corosync cluster run full speed on 10Gbe?
Corosync was not tested in 10Gbe environment (with exception of IBA). And honestly, I don't think 10Gb can be achieved with standard MTU. So my advise would be to try increase MTU of NIC and then increase MTU in corosync.conf. Also corosync 2.x contains many optimizations so it can behave better. Regards, Honza > > Thanks in advance. > > Bests. > An Yang > > > > _______________________________________________ > discuss mailing list > discuss@corosync.org > http://lists.corosync.org/mailman/listinfo/discuss > _______________________________________________ discuss mailing list discuss@corosync.org http://lists.corosync.org/mailman/listinfo/discuss
