Hey all, I'm currently working on frequency sensing using the HackRF SDR. However, when I calculate the FFT, I encounter a DC offset that's higher than the actual signal strength itself. This offset is interfering with my ability to detect the intended output accurately. Could you please assist me in understanding how to remove this DC offset?
-- *Thanks and Regards* *Arhum Ahmad* Ph.D. Scholar, Electrical Engineering Department, IIT Ropar +91- <+91-7015802356>7974897279 | arhum.19eez0...@iitrpr.ac.in <2016eez0...@iitrpr.ac.in> Lab No. 323, Communication Research Lab, J.C.Bose Building -- **CONFIDENTIALITY NOTICE: The contents of this email message and any attachments are intended solely for the addressee(s) and may contain confidential and/or privileged information and may be legally protected from disclosure. If you are not the intended recipient of this message or their agent, or if this message has been addressed to you in error, please immediately alert the sender by reply email and then delete this message and any attachments. If you are not the intended recipient, you are hereby notified that any use, dissemination, copying, or storage of this message or its attachments is strictly prohibited.* *
