Hello Marcus,
The boards I have are b200 and b210.
I want to change the frequency of 2 SDRs at the same time. Even if I write the
codes in parallel, the frequency of one of the SDRs changes first, and then the
frequency of the other one changes. I want 2 of them to run in parallel.
I looked at the resources you shared and the examples on GitHub. Based on
these, I wrote the following code. But I can't say it worked. I guess I
couldn't get it to work.
tune_rx = pmt.make_dict()
tune_rx = pmt.dict_add(tune_rx, pmt.intern("freq"),
pmt.from_double(center_freq))
self.blocks_message_strobe_0 = blocks.message_strobe(tune_rx, 20)
self.msg_connect((self.blocks_message_strobe_0, "strobe"),
(self.uhd_usrp_source_0, "command"))
self.msg_connect((self.blocks_message_strobe_0, "strobe"),
(self.uhd_usrp_sink_0, "command"))
The hopped frequencies vary, usually in 100MHz steps, and are higher than my
master clock rate.
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows
