Hi Joshua,
the most important questions are:
Can you live with less than 50 M updates/second of the PWM?
How much error in the output PWM is acceptable?
If you need the 50 M updates/s and you want the PWM to be high precision
(like 8 bit resolution or something like that), I would say: Forget it.
You are limited by the bandwidth of the ISM band (100 MHz or 80 MHz,
depending on your location) and I am fairly sure that you are not
allowed to transmit over the full band at the same time.
And what do you mean by "low latency"? Is one cycle ok? 100 cycles?
The only chances you have:
* Reduce the PWM frequency to something reasonable (like transmitting
only 1 MHz updates over the air). You can of course build a system that
gets the 50 MHz as input, processes it, output 1 MHz updates over the
air, and a second system that converts that back to 50 MHz on the
receive side.
* Do it the analog (hardware) way. Modulate the pwm on a carrier at 2.45
GHz with AM/FM whatever, and demodulate it at the receiver. The
demoulation would have to include some sort of rectification. Depending
on the bandwidth and SNR you allow the transmission to have, your
received signal will suffer some additional noise.
* Or go up in frequency. There are ISM bands at 5.8, 24, 61, 122, and
244 GHz with plenty of bandwidth available ;)
Best regards,
Fabian
Am 02.08.22 um 18:45 schrieb White, Joshua J:
First, let me apologize in advance if this isn't the correct forum for
this question.
I have a 50 MHz PWM signal (it's actually a 50 MHz 50% DC clock with a
1PPS clock embedded with PWM) that I would like to transmit over the 2.4
GHz ISM band with as low latency as possible. My original thought was to
digitize the clock with a high-speed ADC, then stream the samples to GNU
Radio and transmit via SDR, then recover on the receive side and
playback the samples with a high-speed DAC. The problem I'm running into
is that the only capture cards I've been able to find capable of running
at the sample rate needed (>500MS/s) and streaming in real-time to GRC
are prohibitively expensive ($8000+).
My question is, is anyone aware of any alternative methods of
transmitting the 50 MHz PWM over ISM? I would be willing to entertain a
different method of streaming to GRC or an entirely different setup. I
don't know of any radios that could take the signal as input directly
and transmit it, then receive it and output it directly, but admittedly
I am rather new to the world of RF so it's possible there's a solution
that exists that I'm simply unaware of.
Very respectfully,
**
*Joshua White*
Precision Timing Systems Engineer
Engineering & Support Solutions Directorate
www.riversideresearch.org <http://www.riversideresearch.org/>
T: 937.986.3153 | F: 937.431.3811
This e-mail message, including any attachments, is for the sole use of
the intended recipient(s) and may contain proprietary, confidential or
privileged information or otherwise be protected by law. Any
unauthorized review, use, disclosure or distribution is prohibited. If
you are not the intended recipient, please notify the sender and destroy
all copies and the original message.
