Hello,
This may be an usrp-users question, but I can't seem to get approved for that
list. Is it possible to use two TwinRX boards (4 channels) in a X310? As far
as I can tell you need 4 DDCs, but only two are available by default.
A followup: why is it that TwinRX connection type is reported as 'Connection
Type: II' for channel 0 QQ for channel 1.
Finally, I have a twinrx and a UBX board in one X310. Trying to run all 3 RX
at the same time I get:
UHD Warning:
[X300 Radio] Requesting invalid sampling rate from device: 100 MHz. Actual
rate is: 200 MHz.
thread[thread-per-block[0]: <block gr uhd usrp source (1)>]: RuntimeError:
Conflicting tick rates: One neighbouring block specifies 2e+08 MHz, another
1e+08 MHz.
[cid:image001.png@01D2F424.CD93A110]
Thanks
_______________________
Eugene Grayver, Ph.D.
Aerospace Corp., Sr. Eng. Spec.
Tel: 310.336.1274
________________________
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
