Hii want to decode a bell push signal from typ FS20 TK by Using HackRF one
.The frequenz is 868.35 MHz the modulation is AM. I use 19.2k Baudrate.The
Bell push use a ook protocol. I use the Sample rate from 2 MHz.to my flow
graph i use a low pass Filter a complex to mag block as demodulator, a M&M
clock recovery and binary slicer and at the end a File sink.When i generate
the graph i became into the file sink a sequence of bit
010101010101010101010..... from start to the end. I would like to see the
entire packet (including the preamble and sync word). A signal can not just
have a sequence of bit like 0101010101010101... from the start to the end.
I also use a other equipment with the same Frequenz but i still become the
same sequenz of bit. i don't know my mistake .Please can anyone help
me?Thanks Rebecca
--
View this message in context:
http://gnuradio.4.n7.nabble.com/decoding-a-AM-Signal-into-a-sequence-of-bits-tp57106.html
Sent from the GnuRadio mailing list archive at Nabble.com.
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
