Hi Hoang,

Yes it's a problem with your design. You have 2 Msps feeding into an audio
sink that probably goes up to 48 ksps. You need to change your sample rate
from 2 Msps to a rate your sound card supports. I would target one of the
default rates you can select from the audio sink. You can use polyphase
arbitrary resampler block with the proper resampling ratio 2M/48k entered
leaving the taps blank and the other parameters to default.

Hope that helps,
Rich

On Fri, Aug 28, 2015 at 2:19 PM, Hoang Nguyen Tran <hoangn...@gmail.com>
wrote:

> Dear all,
>
> I have just built a FSK receiver aim to receive Cubesat data with FSK
> modulation with 9600 baud rate, below is my flow graph.
> I have just tested it with usb dongle RTL-SDR, however when I'm using
> audio sink, I received  OOOOO (overrun I think) continuously .
> Does it have anything wrong with my set up ?
>
> samplerate 2M
> cut off freq 9600
> transition 4800
>
> I really appriciate for any comment on my FSK receiver flowgraph, I am a
> newbie :)
>
> Thank you and best regard,
> Hoang
>
> --
>  -HoangNT-
> PhoneNo :  +841654248782
> Skype : hoangastro
> FB : https://www.facebook.com/kenshin.rorouni
>
> _______________________________________________
> Discuss-gnuradio mailing list
> Discuss-gnuradio@gnu.org
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Reply via email to