Sometimes it's safer to clear the build dir, usually it's OK to leave in. If you have any cmake variables set, you'll need to reset them if you clear the dir.
UHD is updated the same way. In all cases, it depends where you installed your stuff. pybombs can do all this for you, by the way: ./pybombs update ...although I don't think this will update pybombs itself. M On 10/29/2014 08:53 PM, Richard Bell wrote: > Hi all, > > I am new to all of this, so I'm looking for some guidance. I recently > setup UHD and GNURadio using PyBOMBS on Ubuntu 14.04. I now want to do a > git pull and update my stuff. I'm not sure what commands to execute > after I do the git pull for each. > > For example, I found two different recommendations for updating gnuradio > after a git pull > > First way: > > *git pull > * > *rm -Rf build > * > *mkdir build > * > *cd build > * > *cmake ../ > * > *make > * > *sudo make install* > > Second way: > > *git pull > * > *cd build > * > *make > * > *sudo make install* > > Is the removal of the existing build directory and cmake command necessary? > > After executing git pull, what directory do I need to go to and commands > do I need to run for PyBOMBS and UHD? > > v/r, > Rich > > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
