Re: [Discuss-gnuradio] sample time alignment in GRC

[Marcus Leech]

Make sure that you specify that the 2nd X310 uses external clock and 1PPS, and all of them should use time synch of

  "unknown PPS".

 

Also, there has been a bug in the scope sink (dunno if fixed) where samples are *not* time-aligned in the scope sink.  The except

  is that a complex-pair will be time-aligned internally, but not necessarily to other streams being displayed.

 

 

 

on Jun 13, 2014, Lapointe, Benjamin - 1008 - MITLL <blapoi...@ll.mit.edu> wrote:

Hi,

 

I have two USRP X310 devices that I am trying to time align in GNU Radio Companion.  One X310 has a GPSDO that is sending 10 MHz reference and 1 PPS signals to the other one. The GPS is locked.  Ideally I would have matched length cables for 10 MHz reference and 1 PPS, but I think my setup is close enough. (Input signal from sig gen = pulsed 10.005 MHz, input is split with matched length cables, USRP output sampling rate = 5M, USRP center frequency = 10M.) 

 

I am using WX GUI Scope Sink to look at the magnitudes of each stream from the USRP devices.  I expect to see no/minimal delay between the two signal streams, but I am seeing delays of 24, 13, 9, 0, 3, 6, 25, 24 samples from run to run between the two signal streams.  The period of the signal is 50 samples, so the maximum delay difference is 25 samples.  Am I missing something in my configuration?  Since I am using a 10 MHz reference and 1 PPS signals, I expect time alignment between the two sample streams.  Is there a GRC block for forcing time alignment? 

 

Thanks!

-Ben

---

_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio