Hi all guys,
I would like to receive in my application signals from WBX board and from
LFTX simultaneousely.
At the moment, when I run the flow graph it ends immediately with core
dump, and zero divisin exception.
In the script, sources are defined in this way:
self.uhd_usrp_source_0 = uhd.usrp_source(
device_addr="",
stream_args=uhd.stream_args(
cpu_format="fc32",
channels=range(1),
),
)
self.uhd_usrp_source_0.set_subdev_spec("A:0", 0)
self.uhd_usrp_source_0.set_samp_rate(samp_rate_wbx)
self.uhd_usrp_source_0.set_center_freq(433900000, 0)
self.uhd_usrp_source_0.set_gain(input_gain_slider_wbx, 0)
self.uhd_usrp_source_0.set_antenna("RX2", 0)
and the second:
self.uhd_usrp_source_1 = uhd.usrp_source(
device_addr="",
stream_args=uhd.stream_args(
cpu_format="fc32",
channels=range(1),
),
)
self.uhd_usrp_source_1.set_subdev_spec("B:A", 0)
self.uhd_usrp_source_1.set_samp_rate(samp_rate_CC1000)
self.uhd_usrp_source_1.set_center_freq(freq_CC1000, 0)
self.uhd_usrp_source_1.set_gain(gain_CC1000, 0)
There are certain posts about using different firmware, but I am not able
to figure out what should I really do, and is that necessary?
Thanx for help,
Best,
--
Nemanja Savić
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
