Hello All,
I've been trying to connect a USRP N200 to a PC, however, I had no
success.
During some seconds, the connection is established, I do can ping the
IP 192.168.10.2 and find the device by uhd_find_devices command, but
then it dies.
The LEDs D and F remain on.
I could not even install the FPGA image into it.
I am using Gnuradio 3.6.4.1, Ubuntu 12.04 and Realtek Semiconductor
Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 09).
Can somebody give me a hint?
Best Regards,
--
Felipe Fideles
Electrical Engineering Undergraduate Student
Federal University of Campina Grande - UFCG - Brazil
Electrical Engineering
San Diego State University
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
It's very likely that you have DHCP still turned on on that port (via
network manager). This means Network Manager will "probe" for a DHCP server
a few times before taking the port down, and you're likely seeing
"success" only during the window when Network Manager is still looking for
a DHCP server. Turn off the automatic address assignment on that
port, and make sure that it has a static address.
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
