________________________________ > Date: Mon, 10 Jun 2013 18:00:21 -0400 > From: ankan...@gmail.com > To: discuss-gnuradio@gnu.org > Subject: [Discuss-gnuradio] USRP_N200 unable to connect via vmplayer > > I have vmplayer virtual machine running on my computer as my system is > GPT partition style and which is not taking dual boot of any release of > ubuntu. > > I connect to an ethernet port to a USRP rx... and do a uhd_find_devices > .. it says no device found.. although I have a valid gnuradio distro > +uhd on my computer and it works fine when I am not using the USRP > though.. > > Could it be because of the vm that I am using? Please suggest what do I > need to do!! > > this is my eth0 config- > > eth0 Link encap:Ethernet HWaddr 00:0c:29:23:94:4e > inet addr:192.168.10.1 Bcast:192.168.10.255 Mask:255.255.255.0 > inet6 addr: fe80::20c:29ff:fe23:944e/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:39419 errors:0 dropped:0 overruns:0 frame:0 > TX packets:14888 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:48827305 (48.8 MB) TX bytes:1521561 (1.5 MB) > Interrupt:19 Base address:0x2000 > > > This shows up when I am doing my firmware update- > > > ankan@ubuntu:~/Downloads/uhd-images_003.005.001-release/share/uhd/images$ > usrp_n2xx_simple_net_burner --addr 192.168.10.3 --fw usrp_n200_fw.bin > --fpga usrp_n200_r3_fpga.bin --auto_reboot > linux; GNU C++ version 4.6.3; Boost_104800; UHD_003.005.003-78-g49a4929b > > Searching for USRP N2XX with IP address 192.168.10.3. > Error: No USRP N2XX found. > > my machine is 192.168.10.1 .. the usrp is on 192.168.10.3 via same > ethernet sw > > > > -Regards, > Ankan Roybardhan > University of Florida. >
You're sure its not at the default address 192.168.10.2? Don't know if you have the same problem but I use a USB to GigE adapter from vmware player and I found that it ONLY works if I boot the VM with the interface that is connected to the USRP as the only active network connection. I can enable the network interface to the host OS after I boot and it still works but for some reason if the VMnetX interfaces are active at boot it messes up the ability to find the USRP. -Clark _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
