On 02/12/2013 12:10 PM, John Wilson wrote:
Hi,
I'm wondering whether it's possible/how to use a USRP1 with 2x DBSRX boards
to generate 4 separate streams via the 4rx usrp1 firmware. The required
channels will be within the front end bandwidth of the DBSRX2.
At the moment I'm using a subdev spec of 'A:0 A:0 B:0 B:0' which I assume
runs the signal from subdev A through RX chains 0 and 1, and subdev B
through 2 and 3. Is this correct?
That seems correct.
I am planning to set each daughter board to a frequency between its two
frequencies of interest, then I'd like the DDCs to downconvert the data
from the ADC independently to sit the two frequencies of interest in the
centre of their respective baseband channels out of the USB bus. So can I
change the DDC frequencies independently of the centre frequency in the
You will want a tune_request object where the rf_freq is set to the
desired center frequency of the DBSRX (something in between that each
CORDIC can shift away from). And set the rf freq policy to manual.
There are some examples of making the tune request in the grc block for
usrp source properties dialog box.
daughterboard? Also what is the resolution of the DDS in the DDC, i.e. can
I tune each one independently in ~1Hz steps?
The CORDIC resolution is pretty much 64e6/(1<<32), so sub Hz.
-josh
Also, will he need to use the 4rx FPGA image, or will UHD automagically
use the right image?
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
