I know this is a stupid question, but I've been bitten by this before:
Are you SURE you're cabled to the Tx/Rx connector and not Rx2? @(^.^)@ Ed On 2/10/12 4:30 PM, Reginald Cornwallice wrote:
Hello All, I'm having an issue with the transmit power on N210 + WBX not being able to reach the spec'd 100 mW on the data sheet. I'm transmitting a PN sequence at a rate of 1.2 Mchips/second. The values I'm sending to the DAC are +/- 24000 which is a little bit below the full range of the DAC, but not much. I've set the TX_GAIN parameter to its maximum value of 25. I measure the output transmit power with a ladybug powermeter and get -15 dBm peak power. This is well below the spec of 20 dBm. Any ideas out there what could be wrong? Does the tx_gain of 25 set all the gains of the LO, IQ modulator, etc? What is controlled and set by setting set_tx_gain to 25? Thanks Reginald
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
