hi nick, thanks for your reply i tried the same command line arguments you gave me but the problem that there is always an under run error even if i change the args i tried several combinations but none of them worked any suggestions about that underrun problem
thanks, osama > Date: Tue, 13 Dec 2011 08:50:36 -0800 > Subject: Re: [Discuss-gnuradio] UHD problem > From: n...@ettus.com > To: osama_valencia...@hotmail.com > > Are you using tx_waveforms? How are you measuring the received signal? Try > this: > > ./tx_waveforms --ampl=0.5 --rate=4e6 --gain=20 --wave-type=SINE > --wave-freq=10e3 --freq=1.1e6 > > This should produce a tone at 1.11MHz on the TX_A output of the BasicTX. > > If you don't see the desired tone, please cut and paste the entire > output of the command. > > --n > > 2011/12/13 osama mohamed <osama_valencia...@hotmail.com>: > > hi all, > > > > i am using usrp1 and a basic tx when i run any uhd example that transmits > > data i see the meta data going out from the fx2 to the fpga but it never > > goes to the codec so no signal is generated > > > > any help is appreciated > > > > osama > > > > _______________________________________________ > > Discuss-gnuradio mailing list > > Discuss-gnuradio@gnu.org > > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
