On Tue, Oct 25, 2011 at 3:53 PM, Jordan Otomo
<jot...@skyboximaging.com <mailto:jot...@skyboximaging.com>> wrote:
Hi Tom,
Thanks for the help. I've tried manually deleting all of the GNU
Radio files in the recommended locations, reinstalling, and
performing a 'sudo ldconfig', but the problem still persists. You
mentioned a few install directories not listed in the FAQ's "The
problem of multiple installs" section. Do you know if there are
any other install files I should delete before reinstalling?
Thanks again!
Jordan
That FAQ does list all of the install directories; I was just a bit
more explicit in my email about where they are (subdirs in lib and
share, for example; and I missed the bin directories). That should be
it; anything else shouldn't be causing you problems.
What OS are you running? Are you building with cmake or autotools? Any
configure-time failures?
Tom
----- Original Message -----
From: "Tom Rondeau" <trondeau1...@gmail.com
<mailto:trondeau1...@gmail.com>>
To: "Jordan Otomo" <jot...@skyboximaging.com
<mailto:jot...@skyboximaging.com>>
Cc: discuss-gnuradio@gnu.org <mailto:discuss-gnuradio@gnu.org>
Sent: Tuesday, October 25, 2011 12:01:30 PM
Subject: Re: [Discuss-gnuradio] Problem with WXGUI Widgets
On Tue, Oct 25, 2011 at 2:43 PM, Jordan Otomo <
jot...@skyboximaging.com <mailto:jot...@skyboximaging.com> > wrote:
Hi,
I seem to be having an issue with a few of the GRC WX GUI Widgets,
namely the FFT Sink and Scope Sink, in the latest release (3.5.0).
My flowgraphs now exit immediately, without error. I've
constructed a simple flowgraph consisting of a signal source,
throttle, and FFT Sink/Scope Sink to test this and it exits
immediately after execution. The only message I receive is ">>>
Done". Any help would be greatly appreciated.
Thanks,
Jordan
It might help to remove all of the old GNU Radio installed files
from your system (in prefix/lib/libgnuradio*,
prefix/lib/python2.X/dist-packages/gnuradio,
prefix/include/gnuradio, prefix/share/doc/gnuradio,
prefix/share/gnuradio).
You shouldn't have to do this, but it seems a common cause of
problems when upgrading.
Then reinstall and make sure to run ldconfig.
Tom
I did a build-from-cmake on a Ubuntu 10.10 system this afternoon, and
the WX GUI sinks work just fine afterwards. I did have to
do a "sudo ldconfig" when I was done, but that was it.
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
