On 29/07/2011 12:40 PM, Burak Kelleci wrote:
Hi,
I am trying to send data from a N210+XCVR2450 to another N210+XCVR2450.
Both equipment have antennas connected at J2 antenna input and they are
connected to the same computer using 2 gigabit ethernet ports. I have
assigned different ip addresses and executing "uhd_find_devices" gives the
following result
Try this experiment.
Wire your antenna for J1 (the default) on one of the N210 units (after
installing the correct firmware, as noted by Nick).
Use uhd_fft.py --f 5.5G -g 40 -s 5.0e6
And see if you can 'see' the unit that is transmitting at 5.5G. You
should see two spikes--at +100Khz and -100Khz.
Also check other frequencies that you should be able to see, like your
local WiFi 2.4GHz signals.
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
