I am interested in this 2 USRPs approach since I don't have the experience and the knowledge to start messing about inside the FPGA firmware code and have an extra USRP2. How would this go? I tried looking up some info about this topic but currently gnuradio.com seems to be down. I've read some bits and pieces on a few forums. Most of the info is about having one USRP2 module as a transmitter and the other as a receiver. I want them both to be receivers(actually half a receiver) and to complete each other by receiving half of the 32 MHz band (so each would receive 16 MHz). How would the USRPs be connected to the same computer? How will the two 16 MHz bands be attached together to form the 32 MHz one (some kind of 2:1 multiplexing - I'm just guessing here)? I am aware of the great load exerted upon the system resources, but I'm trying to make this work anyway. Thanks.
Vlad. Marcus D. Leech wrote: > > On 11/29/2010 08:57 PM, Abdalaleem Andy James Potter wrote: >> You could use 2 USRPs and chop it down the middle? >> >> Reconstruct on the computer? >> >> > Yup, although see my previous comments about host-side resources > required for such wide bandwidths. > > > -- > Marcus Leech > Principal Investigator > Shirleys Bay Radio Astronomy Consortium > http://www.sbrac.org > > > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > -- View this message in context: http://old.nabble.com/USRP2-%2B-WBX-How-to-use-a-32-MHz-signal-band--tp30335430p30338714.html Sent from the GnuRadio mailing list archive at Nabble.com. _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
