On Thursday, November 04, 2010 02:35:32 pm Tom Rondeau wrote: > On Thu, Nov 4, 2010 at 5:06 PM, Eric Blossom <e...@comsec.com> wrote: > > On Thu, Nov 04, 2010 at 10:17:04AM -0700, Steve Mcmahon wrote: > >> It took me a while to get some time to go back to my openSUSE 11.3 > >> machine and regenerate the error message. Sorry, I should have done > >> this when I made the initial post. > >> > >> So I successfully installed the following from source under openSUSE > >> 11.3: > >> > >> Cheetah-2.4.2.1.tar.gz > >> Markdown-2.0.3.tar.gz > >> cppunit-1.12.1.tar.gz > >> fftw-3.2.2.tar.gz > >> gsl-1.14.tar.gz > >> numpy-1.4.1.tar.gz > >> sdcc-2.9.0-i386-unknown-linux2.5.tar.bz2 > >> swig-1.3.40.tar.gz > >> > >> Then I do a "./configure" for GNU Radio 3.3.0, and it runs fine, and it > >> reports it's going to build everything that I need/that it should. > > > >> However, when I do a "make", it runs for a while, but then I get these errors: > > There's a much easier way to get where you're headed. > > > > Use the "master" branch in git. I'm pretty sure it has this problem > > fixed. > > > > http://www.gnuradio.org/redmine/wiki/gnuradio/Download > > > > Eric > > I just tried compiling from maint, master, and next on a new OpenSUSE > 11.3 installation and all three compiled fine. It fails from the > tarball for GNU Radio 3.3.0. > > So use one of the git versions for now. If you're on a machine not > connected, just git clone gnuradio (master is probably the best branch > to use) and tar it up to move it across to the other computer. That > should work for you. > > When we get 3.3.1 out, this problem will be fixed. > > Tom > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio There is a patch for GCC4.5. I found it on Fedore. let me know if you ned it -- Thomas
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio