Hi there,
I have tried to use the C++ interface
"test_usrp_standard_rx.cc" to transmit data between 2 USRP board.
On the RX side, I cannot get received data right if I split
the bit stream coming out of buffer into 2 ways, assuming one way to be I data
and the other to be Q data. However, when I split the bit stream into 4 ways,
and I can get received data right if I use way1 and way2 as I and Q data.
I think the problem may lies in a little mistake in the default register
configuration for the RX mux in "test_usrp_standard_rx.cc" because I found that
the number used to configure RX mux in python interface is different from that
in C++ interface. Hopefully there is someone can verify it.
Best regards,
Todd Wang
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
