I envisioned a way to send a burst with a request to ACK. If you enabled
the ACK, you would expect a async message to come back either one of the
errors or a success. This is not implemented.
-Josh
On 09/09/2010 09:54 AM, Marc Epard wrote:
As far as I can tell, EVENT_CODE_SUCCESS (Defined as success: a packet was
successfully transmitted) events never seem to happen. That's okay with me and
I'd worry about the bandwidth they'd take if I were transmitting and receiving
at the same time. Are they just not implemented, yet?
I need to start and stop transmitting, do some work, and go around again. I
think I'm seeing residual events after I end a burst. Should I use the
metadata's timestamp to filter them out or is there a way to flush the queue of
events?
-Marc
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
