Hello,
I am working on a similar project to use a USRP 1 as a RADAR device for
a temperature measurement application. I am not sure about the USRP2,
but for USRP1 it is possible to send a signal from the FPGA to the DACs
without interpolation through manipulation of the FPGA registers and by
using custom verilog code. The most relevant example would be
usrp_radar_mono. I am not sure if there is similar code for the USRP2.
~Jeff
On 8/2/2010 10:59 AM, Cheaw Wen Guey wrote:
Hi,
I think I may not be the first to ask this but here is my problem.
I am designing a radar receiver using a USRP2. My transmits and receives
are done in pulses. The problem is that I require 80MHz bandwidth and the
USRP2 can only reach 25MHz. I understand that this is due to to the
limitation of the GB ethernet. I would like to bypass the DDC and then
make it not real time to allow the data to be transmitted as I do not
require the system to be realtime.
My questions are:
1) Where should I be looking, in the VHDL or the USRP2 firmware to modify
to allow full bypass?
and
2) I am still trying to understand how to receive on time. Any examples to
refer to?
Cheaw Wen Guey
Research Officer
--
~Jeffrey Lambert, K1VZX
--
~Jeffrey Lambert, K1VZX
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
