Juan, Thanks a lot for your response. I tried stopping at the ifconfig stage and wait for both PCs to be ready before hitting enter. But all I saw was TX and no RX. Do you have any idea where the problem might be?
Tuan On Wed, Jul 7, 2010 at 7:10 PM, Juan Quiroz <asd...@yahoo.com> wrote: > I have installed deb package of GNU radio 3.2.2 for Ubuntu 9.04 and works > fine, with openSUSE 11.1 I try tarball and everything is OK, for openSUSE > there's a rpm package of GNU radio 3.1.3 avalaible in > http://software.opensuse.org/search it's ok too. > > Try doing this step by step > Run tunnel.py, in Ubuntu sudo tunnel.py -f 24xxe6 -c x x can be whatever > you want. > > You will see an output asking to allocate gr0 > > Set an IP address with sudo ifconfig gr0 192.168.200.1 netmask > 255.255.255.0, don't press enter > > Wait here and go to next PC and repeat the same, but press enter when both > PCs are ready > > If everything is fine immediately in console you will see RX and TX because > of communication is beginning, is there's only TX messages we have a > problem, if BBBB is in your screen, it means back off no carrier sensed, try > to change it with -c option. > > Again good luck > > Juan Quiroz > > > >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
