Hi, I'm currently working on a few changes to the FPGA image, but I ran into some strange issues that I want to bring up here.
1. It seems that txrx_edk10.1_3.3git-645-gb811e87.bin from the binary builds in http://gnuradio.org/releases/usrp2-bin/trunk/ is not properly working with both the latest provided u2_rev3.bin as well as a custom build one from the latest git version of the gnuradio firmware. The hardware boots up, the LEDs flash correctly, and the find_usrp2 also works, but the usrp2_fft.py seems to work at first, but the samples provided seem like noise, although in normal operation signals are visible. Additionally, switching the channel seems to work as well, but there is just different levels of noise everywhere. When changing the decimation value from 16 to 4, the fft (and probably the hardware) hangs. Revision txrx_edk10.1_3.3git-594-g02616cf8.bin seems to work correctly. Either I'm doing it wrong, or there are some issues with the firmware. I tried this with the XCVR2450 board. 2. The Xilinx tools in version 11.1 are without patches not able to generate the bitstream, even make proj failed. The build also fails because it needs more RAM than available with a self-made project. With the latest service pack (sp 5) the software is able to produce a .bin file, but not even the LEDs flash with this version. There are a lot of warnings, so I cannot tell what the problem is, but it seems that successful compilation is not enough to make it work. I made an .ise file with make proj and imported it into ISE, so maybe some vital information got lost in the process, but since the logic is given i cant understand how something could go wrong here. 10.1 sp3 works correctly as expected. I'm willing to play around with 11.1 a bit more, so if you have some ideas on how to debug this, I can invest some time into this. Matthias _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
