Hi,
I am transmitting the sinusoidal wave form (IQ samples), in the
following methods, and found that when i stem plot in the MATLAB both
the input wave form data on one USRP2 and the received data on another
USRP2, initially the waveform is exactly fitting (i mean overlapping),
and after certain samples, it starts ie., in the input wave form and the
output data waveform drifting slightly and at the end samples both the
waveforms overlaps perfectly. Why this slight drifting is happening when
transmitting the I Q samples from one USRP2 to another USRP2.
1st method:
I used, tx_samples.cc and receive_streaming_samples.cc.
2nd method:
Using the GRC, created a signal source, and file sink and usrp2 sink
on One PC and another PC usrp2 source and file source. So plotting both
the input stored samples and output received samples, observed the above
mentioned drift of mismatch of samples of the waveform and again at the
end and start it perfectly matches or overlaps.
Kindly help me in understanding this phenomena, why this is happening on
raw data (IQ) samples sending. But this never happens, when i checked
with the benchmark_rx.py and benchmark_tx.py used (as internally these
two are using GMSK modulation, sync work and packets framing method).
best regards,
srinivas.
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
