I have a similar problem too as I'm just starting to use USRP and I haven't had a lot of success so far.
I'm trying to do a basic xmit/recv. to make sure my 2 USRP devices are working fine. I'm using a RFX 2400 daugtherboard, and so I'm transmitting at 2.5GHz. I can transmit using the usrp_siggen.py program to transmit either a 100kHz or a 1000kHz sine wave, and the program runs fine. But I don't think I can see the signal on my receiver, which is the second USRP device hooked up to a separate computer. I'm using the usrp_fft.py and usrp_oscope.py programs for this purpose, and I can only see noise in both cases. The usrp_fft program shows a peak at the tuned frequency, but that's doesn't really say anything, since it shows the peak no matter what frequency I tune it to. The two USRPs are next to each other, so I can't imagine why I'm not getting anything at all! Suggestions? -- Posted via http://www.ruby-forum.com/. _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
