Here is the output, thanks for taking some time in this.
Natalia
[EMAIL PROTECTED]:/home/nol/mobnets/testbed# /sbin/ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:1e:37:1e:ee:4a
inet addr:134.130.222.127 Bcast:134.130.222.255 Mask:255.255.255.0
inet6 addr: fe80::21e:37ff:fe1e:ee4a/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1400 Metric:1
RX packets:16302010 errors:3 dropped:19 overruns:0 frame:2
TX packets:21446 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3178136520 (2.9 GB) TX bytes:3379674 (3.2 MB)
Base address:0x1840 Memory:fe200000-fe220000
2008/11/3 Eric Blossom <[EMAIL PROTECTED]>:
> On Mon, Nov 03, 2008 at 11:51:09AM +0100, Natalia Olano wrote:
>> Hello,
>>
>> I am using the USRP2 with an RFX2400 daughterboard in Ubuntu Hardy
>> 8.04.1, installation went fine (used rev 9913 plus the ready made
>> firmware images in http://gnuradio.org/releases/usrp2-bin/trunk) and
>> usrp2_fft.py works perfectly.
>>
>> However, I experience the following problem when invoking usrp2_siggen.py:
>>
>> [EMAIL PROTECTED]:/home/nol/gnuradio_V_9913/gr-utils/src/python# python
>> usrp2_siggen.py -f 2.4G -w 200k
>> ethernet:write_packetv: send: Message too long
>> usrp2_sink_32fc: tx_32fc failed
>>
>> I would appreciate some help
>> Thanks
>> --
>> Natalia Olano
>
> Thanks for pointing out the problem. I haven't seen this one before.
>
> Can you run this command and post the output?
>
> $ /sbin/ifconfig eth0
>
> Thanks,
> Eric
>
--
Natalia Olano Agüero
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
