On Fri, Aug 8, 2008 at 9:15 AM, Halil Yigit <[EMAIL PROTECTED]> wrote: > Hi > > I'm new to the GNURadio, so I'm trying to get some of the > basic tests. I am using Flex 2400 daughterboard
This is important later on ... > I've run the dial_tone.py example, and it is running. for usrp, I have > tested usrp_wfm_rcv.py. I've connected daughterboard to RXB and TXB. > Then I write ./usrp_wfm_rcv.py -f 96.5M, I get an error message as follows > 1. FYI: No powermate or Contour Knob > 2. Failed to set initial frequency (on USRP WFM RX screen) > 3. (python 6931): GnomePrintCupsPlugin-WARNING **: The CPUS > printer couldnt be created ... as it seems you're trying to tune a Flex 2400 to 96.5MHz. You need to either: - Tune to a frequency the Flex 2400 can tune - Acquire a board that can tune to the frequency of interest (96.5MHz) Brian _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
