On Fri, Apr 25, 2008 at 05:27:23PM -0400, Jennifer Ann Petersen wrote: > Hi there, > > I'd like to use the GigE MAC module for the USRP2 on a piece of (non-USRP2) > hardware, but due to project constraints am not able to use GigE or 100Mbps. > Does the module support 10Mbps? From the comments in the change logs, I'm > guessing not, but just wanted to make sure. From an earlier post on this > discussion board it looked like the USRP2 itself might be able to handle > 100Mbps or 10Mbps, so I was curious about the implications for the MAC > module... > > If by some chance it does support 10Mbps, would the signal labeled > ".Clk_125M" still need to be a 125Mhz clock? Does ".Clk_user" need to be a > 100Mhz clock, as in the demo code? > > Thanks much! > Jennifer
If you want a 10Mb/s MAC, I think the 10/100 MAC at opencores would be a better starting point. Eric _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
