For anyone working with the OFDM code, my latest check-in to the trunk
fixes some of the main issues of transmitting over the air. Using
benchmark_ofdm_rx and benchmark_ofdm_tx on different machines, I am now
able to successfully capture most packets with any modulation at the
appropriate signal level.
I say most packets because there is still an issue involved in the
receiver where the regenerator signal pops up before the peak detector
signal resets it and causes a problem in the packet sampler. To see what
I mean, run
"benchmark_ofdm.py --log"
And look at the output of the regen and peak detector blocks:
gr_plot_char.py ofdm_sync_pn-regen_b.dat ofdm_sync_pn-peaks_b.dat
This will plot a series of 0's with a few 1's, where the peaks occur.
The peak detector sends it out once, and then the regenerator takes
over. For every packet, there is one output of the peak detector. If you
look, sometimes the peak detector will hit just after a regenerated
signal. By this point, it's too late and the ofdm_sampler has already
triggered off of the regen signal and ignores the peak.
It's a bit of a hassle, but I'll look into it soon. Any help is
appreciated, though :)
Tom
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
