"It seems that BBN codes doesnot work with MIMO dautherboards" ?
At least the rx path should work. I use the wireless card to generate the packet instead of using bbn tx path. In fact I don't think I ever used the USRP to generate any well shaped .11b packets. -Di Mohammad Hamed Firooz wrote: > > > Hi > > I've tried to use BBN code to transmit 802.11 packets by using RFX2400 > dautherboard. When I run "bbn_80211b_tx.py" I get the following message: > > Using TX d'board A: Flex 2400 Tx MIMO B >>>> gr_fir_ccf: using SSE > spb: 8 > interp: 32 > Failed to set Tx frequency to 2.4G > > I went through the code but I could not figure out what the problem > is. I found this message in mailing archive: > > http://lists.gnu.org/archive/html/discuss-gnuradio/2007-07/msg00010.html > > It seems that BBN codes doesnot work with MIMO dautherboards, has > anybody else had the same problem? Is there anybody who can run BBN > transmitter code using MIMO RFX2400 daughterboard? > > regards, > hamed > > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > -- View this message in context: http://www.nabble.com/BBN-code-Failed-to-set-Tx-frequency-to-2.4G-tp15077349p15080422.html Sent from the GnuRadio mailing list archive at Nabble.com. _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
