> -----Original Message----- > From: Eric Blossom [mailto:[EMAIL PROTECTED] > Sent: Friday, January 26, 2007 7:56 PM > To: Bahn William L Civ USAFA/DFCS > Cc: discuss-gnuradio@gnu.org > Subject: Re: [Discuss-gnuradio] B input on BasicRX not working > > On Fri, Jan 26, 2007 at 06:42:46PM -0700, Bahn William L Civ USAFA/DFCS > wrote: > > If I understand you correctly, you are trying to receive a signal sent > > in to the "RX-B" input of a BasicRX board, as opposed to the "RXB" slot > > of the USRP (gotta love the completely clear and unambiguous labeling). > > I share your sentiment about the labeling. > > > If that is the case, then to get input from the B side you need to use > > A:1 as the source (if the BasicRX is plugged in to RXA) and B:1 if it is > > plugged in to RXB. > > > > Where, might you ask, is this and other things like it documented? As > > near as I can tell, it isn't. On about the third time that I asked the > > same question someone on this board finally let me in on the secret. > > Perhaps someone on the list (you?) would like to start by documenting > the typical command line options somewhere in the wiki? >
We've been discussing something very much like this occasionally over the past couple weeks - in particular, how we could contribute useful information and applications to the community. At this point, my main concern is that I know so little that I am almost certain to give out incomplete information. Or, much worse, flat out wrong information which would be worse than no information at all. Having said that, here is my initial contribution. http://gnuradio.org/trac/wiki/ApplicationProgramInterfaces I'm not terribly fond of the layout, but don't know how much control I can actually exercise over it (or how much effort would be involved) _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
