Hi again!
It may not work ? I am doing this as an amateur project. I wish to use WinTV
hardware as an RF spectrum analyser ? Bad idea?
I did read an article on the net where a person had claimed he could make
almost any TV card with a SAA***** chip into a radio spectrum analyser.
I was hoping to do the same with WinTV inspired by him.
I am currently trying to install GNURadio.
Question : FFTW install does not have a seperate installation guide for Cygwin.
It does have installation notes on MinGW. I guess those would do ?
Thank you,
Alex.
Eric Blossom <[EMAIL PROTECTED]> wrote: On Fri, Jan 26, 2007 at 09:04:23AM
-0800, Alex Miua wrote:
> Hello there!
>
> Thank you for your response. I am using WinTV-PVR USB2 .
OK. Not sure if it'll work.
Is there detailed documentation, or are you just supposed to run the
software they give you? If the details aren't available, then I
wouldn't even bother.
> Question : Is this the right way of replying to maintain the thread
> of the discussion ? Ahh well ...time ...say 12 hours will tell me :> )
Yes, it worked ;)
> It is interesting to note that in this mailing list I can't post to
> the message board directly. Is this observation correct?
You must post from a subscribed address, otherwise the post is quietly
ignored.
Eric
---------------------------------
Never Miss an Email
Stay connected with Yahoo! Mail on your mobile. Get started!
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
