On Mon, Nov 07, 2005 at 04:40:29PM -0700, Robitaille, Michael wrote: > >On Sat, Nov 05, 2005 at 05:50:17PM -0700, Robitaille, Michael wrote: > > >> The problem is that the software needs to see the eeprom on the > >> daughterboard that I don't have and really don't need. > > > On Sun, 6 Nov 2005 08:54:21 -0800, Eric Blossom wrote: > > > The code that's been in CVS for quite a while treats "no rx daughterboard" > as if there were a Basic Rx > > > daughterboard attached. > > > See the last few lines for db_basic.py > > Should I get the error message; > > "Warning: Treating daughterboard with invalid EEPROM contents as if it were > a "Basic RX." > "Warning: This is almost certainly wrong... Use appropriate burn-*-eeprom > utility."
Have you tried to butch in a EEPROM to simulate a Basic Rx? If so, either program it, or remove it. On the other hand, you may have hosed up something while modifying your USRP motherboard. > per the code in the last few line of db_basic.py? > > I do not get this message when I run usrp_fft.py -R a:0 > > Mike Eric _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
