Tried that and didn't work. I also tried with the basic RX card. I just put a wire in the middle of the RX-A SMA connector but nothing came out there either. Very odd.
> -----Original Message----- > From: 'Eric Blossom' [mailto:[EMAIL PROTECTED] > Sent: Monday, May 02, 2005 10:53 AM > To: Richard Cagley > Cc: discuss-gnuradio@gnu.org > Subject: Re: [Discuss-gnuradio] using a 48k sound card with wfm_rcv_gui > > On Mon, May 02, 2005 at 11:12:07AM -0700, Richard Cagley wrote: > > That worked. Thanks. > > But, I still only get static (I even have an actual antenna hooked up to > the > > TV card). Is it because of the warning I'm getting? > > > > [EMAIL PROTECTED] usrp]$ wfm_rcv_gui.py 93.7 > > RX d'board A: TV Rx > > RX d'board B: <none> > > usrp_standard_rx::set_decim_rate: WARNING rates > 128 result in > incorrect > > gain. > > >>> gr_fir_fff: using SSE > > Since you are using the TVRX daughter board, you should be using the > tvrx_wfm_rcv_gui.py program. wfm_rcv_gui is for people with no RF > front end. > > Eric _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
