I also use FC3, for wxPython, my way is: from the download page: https://sourceforge.net/project/showfiles.php?group_id=10718 download the following rpms wxPython2.5-gtk2-unicode-2.5.4.1-fc2_py2.3.i386.rpm wxPython-common-gtk2-unicode-2.5.4.1-fc2_py2.3.i386.rpm wxPython2.5-devel-gtk2-unicode-2.5.4.1-fc2_py2.3.i386.rpm
if you r using python 2.4, you should change them correspondingly. That works Dawei --- [EMAIL PROTECTED] wrote: > What is the best way to get wxPython working under > Fedora Core 3? > > I tried to download and build the source, but it has > been very painful. > > When I run the program I typically get core dumps: > > [EMAIL PROTECTED] usrp]$ ./usrp_fft.py > usrp: found usrp rev2 > RX d'board A: Basic Rx > RX d'board B: Basic Rx > Segmentation fault (core dumped) > [EMAIL PROTECTED] usrp]$ > > [EMAIL PROTECTED] usrp]$ ./wfm_rcv_gui.py 10.7 > usrp: found usrp rev2 > RX d'board A: Basic Rx > RX d'board B: Basic Rx > usrp_standard_rx::set_decim_rate: WARNING rates > > 128 result in incorrect > gain. > >>> gr_fir_fff: using SSE > Segmentation fault (core dumped) > > > On a good note, the O'scope works alright > usrp_oscope.py > > Thanks for any assitance... > > > The following was my last build attempt: > > tar zxf wxPython-src-2.5.4.1.tar.gz > cd wxPython-src-2.5.4.1 > mkdir bld > cd bld > ../configure --prefix=$HOME/gr \ > --enable-rpath=$HOME/gr \ > --with-gtk \ > --with-opengl \ > --enable-debug \ > --enable-geometry \ > --enable-sound --with-sdl \ > --enable-display \ > --disable-debugreport \ > --with-libjpeg=builtin \ > --with-libpng=builtin \ > --with-libtiff=builtin \ > --with-zlib=builtin > > make > make -C contrib/src/gizmos > make -C contrib/src/stc > > make install > make install -C contrib/src/gizmos > make install -C contrib/src/stc > > cd ../wxPython > python setup.py build > python setup.py install --prefix=$HOME/gr > cd > > > > I'm using the following support packages: > > tar zxf fftw-3.0.1.tar.gz > tar xzf swig-1.3.24.tar.gz > tar xzf cppunit-1.10.2.tar.gz > tar xzf sdcc-2.4.0.tar.gz > tar zxf xerces-c-src_2_6_0.tar.gz > > > The of the GNU radio core compiles and runs without > any problems. > > > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio > __________________________________ Do you Yahoo!? Yahoo! Small Business - Try our new resources site! http://smallbusiness.yahoo.com/resources/ _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
