To Doug, I haven't checked recently, but believe the rulers always show cm regardless the "input settings" you choose. As I understand it you can define stuff in terms of inches and so on (what I call input settings), but the rulers will still show cm. Some time ago I asked about changing the ruler output and apparently that isn't implemented so it is an opportunity for someone who programs to make a contribution.
To Chris, I think your arithmetic and/or understanding are not correct. I sympathize completely - this is not transparent and I had to mess a round a lot before I was sure I understood how it all worked. I apologize if I have been unable to explain in a way that convinces you. If you have the skill you could look at the code itself and see what can make it better. I don't have that skill so I just had to figure out how I could work with it as it is. I feel like I am getting my money's worth so I don't complain about it anymore. On Tue, Jan 25, 2011 at 8:00 PM, Doug Wellington <d...@rincon.com> wrote: > > There is zoom factor and there is scale. Zoom factor brings you closer > to your work without affecting how the rulers look relative to the page > breaks and grid (and your Dia). Scaling (on the Page Setup dialog with the > margins). Changes the page behind the graphics and the ruler. > > OK, cool. I'm using a 200% magnify in the preferences dialog, but leaving > the scaling at 100% in the Page Setup dialog. > > So, it looks like what I'm seeing isn't directly with the page break > display after all. The problem occurs if you change the length unit to > Millimeter in the preferences dialog, then you get the bogus margin display > in the Page Setup dialog. > > It would be very nice to have a place to set margins permanently in the > Diagram Defaults. (I always use .75" on the long side to make room for > binder holes and .5" on the other three sides.) > > Thanks for your help! > > Regards, > Doug > _______________________________________________ > dia-list mailing list > dia-list@gnome.org > http://mail.gnome.org/mailman/listinfo/dia-list > FAQ at http://live.gnome.org/Dia/Faq > Main page at http://live.gnome.org/Dia > > -- Michael E. Ross NC Solar Center Test Laboratory ================================= (919) 576-0824<https://www.google.com/voice/b/0?pli=1#phones> best (919) 631-1451 cell (919) 513-0418 desk michael_r...@ncsu.edu michael.e.r...@gmail.com ============================= NC Solar Center : www.ncsc.ncsu.edu Professional Directory : www.greenprofessionals.org "The information in this email is provided by the NC Solar Center at NCSU as a public service. The Solar Center strives to provide accurate information, but does not warrant or represent the accuracy, usefulness or reliability of this information. For specific advice, we always recommend that you consult with a professional in the appropriate profession for your needs." Email correspondence to and from this address may be subject to the North Carolina Public Record Law NCGS, Ch 132 and may be disclosed to third parties
_______________________________________________ dia-list mailing list dia-list@gnome.org http://mail.gnome.org/mailman/listinfo/dia-list FAQ at http://live.gnome.org/Dia/Faq Main page at http://live.gnome.org/Dia
