e...@thyrsus.com said: > Given the geometry it looks like it will handle a single HAT with the lid > on, though.
The Adafruit GPS HAT fits fine with the lid on. I think you can get the antenna cable out through the slot they left for a ribbon cable to hit the 40 pin GPIO connector. But I've been happy with the built-in patch antenna. I may have mentioned this before. Getting the Pi into that case is a bit tricky. You have to tilt it to poke the HDMI connector and friends into the holes and then rotate the other side down. That doesn't work with the HAT on. You might want to put a string through the mounting holes on the HAT nearest the 40 pin connector so you can remove the HAT. At least one of the GPS HATs looks like it has an antenna connector that will need a hole cut in most case designs. I've seen one "case" that was 2 sheets of plastic and 4 posts in the corners. That left all sorts of room for cables to go in/out the sides. I don't remember where I saw it. -- These are my opinions. I hate spam. _______________________________________________ devel mailing list devel@ntpsec.org http://lists.ntpsec.org/mailman/listinfo/devel
