On Wed, 21 Sept 2022 at 14:27, Gerd Hoffmann <kra...@redhat.com> wrote: > > On Wed, Sep 21, 2022 at 11:24:11AM +0000, Lu, Ken wrote: > > > > > > > But either in GenericQemuLoadImageLib, it can do measurement for > > > command line and initrd, correct? > > > > > > Yes, it could. But why given that the linux kernel efi stub measures > > > anyway? > > > If the final decision is the measurement should be done by efi stub in > > Linux kernel. > > The reference should be the workflow when you boot linux from efi shell > or using a BootNNNN entry. Which I think is: > > (1) linux kernel is loaded + measured via Loadimage(). > (2) linux kernel is started via efi stub entry point. > (3) linux kernel efi stub loads and measures the initrd. > > Not fully sure about the command line measurement, IIRC Ard described > that in one of the replies. >
If the image was booted from a BootNNNN entry, the entire variable will be measured into the TPM, including the load options aka command line. If you use the shell or another loader that has no explicit awareness of secure boot or measured boot, the load options are not measured at all. > > Do we also need remove today's measurement in Grub (I > > have submitted some patch for TDX in grub...)? > > Those patches are perfectly fine, tpm measurement and tdx measurement > should be consistent. In case the grub measurement workflow needs > changes to avoid double measurements (not sure this is actually the > case) those changes should apply to both tpm and tdx. > Agreed. I think the decision what to measure and what not to measure is orthogonal to the type of measured boot that is being used. > > According to Bottomley, the same measurement should not be done twice. > > Yes, this is the way it should be, although the current state of affairs > is a bit messy and I think we are a bit away from that ideal. > > > Or only the one who use GenericQemuLoadImageLib, will give the Linux > > kernel efi stub for measure? > > I think we don't have to do anything special in GenericQemuLoadImageLib > because the lib uses Loadimage() which should handle measurement. > -=-=-=-=-=-=-=-=-=-=-=- Groups.io Links: You receive all messages sent to this group. View/Reply Online (#94080): https://edk2.groups.io/g/devel/message/94080 Mute This Topic: https://groups.io/mt/93737108/21656 Group Owner: devel+ow...@edk2.groups.io Unsubscribe: https://edk2.groups.io/g/devel/unsub [arch...@mail-archive.com] -=-=-=-=-=-=-=-=-=-=-=-
