Reported-by: Taekho Nam <th...@smartx.kr> Signed-off-by: Gurucharan Shetty <g...@ovn.org> --- AUTHORS | 1 + INSTALL.Docker.md | 23 +++++++++++++++++++---- 2 files changed, 20 insertions(+), 4 deletions(-)
diff --git a/AUTHORS b/AUTHORS index 704ba40..5d86dc6 100644 --- a/AUTHORS +++ b/AUTHORS @@ -432,6 +432,7 @@ Salvatore Cambria salvatore.camb...@citrix.com Soner Sevinc sevi...@vmware.com Stephen Hemminger shemmin...@vyatta.com Suganya Ramachandran sugan...@vmware.com +Taekho Nam th...@smartx.kr Takayuki HAMA t-h...@cb.jp.nec.com Teemu Koponen kopo...@nicira.com Thomas Morin thomas.mo...@orange.com diff --git a/INSTALL.Docker.md b/INSTALL.Docker.md index fd082cb..4525b44 100644 --- a/INSTALL.Docker.md +++ b/INSTALL.Docker.md @@ -110,10 +110,11 @@ pip install Flask ``` Start the Open vSwitch driver on every host where you plan to create your -containers. +containers. (Please read a note on $OVS_PYTHON_LIBS_PATH that is used below +at the end of this document.) ``` -ovn-docker-overlay-driver --detach +PYTHONPATH=$OVS_PYTHON_LIBS_PATH ovn-docker-overlay-driver --detach ``` Docker has inbuilt primitives that closely match OVN's logical switches @@ -257,10 +258,12 @@ Source the openrc file. e.g.: ``` Start the network driver and provide your OpenStack tenant password -when prompted. +when prompted. (Please read a note on $OVS_PYTHON_LIBS_PATH that is used below +at the end of this document.) ``` -ovn-docker-underlay-driver --bridge breth0 --detach +PYTHONPATH=$OVS_PYTHON_LIBS_PATH ovn-docker-underlay-driver --bridge breth0 \ +--detach ``` From here-on you can use the same Docker commands as described in the @@ -269,6 +272,18 @@ section 'The "overlay" mode'. Please read 'man ovn-architecture' to understand OVN's architecture in detail. +Note on $OVS_PYTHON_LIBS_PATH +============================= + +$OVS_PYTHON_LIBS_PATH should point to the directory where Open vSwitch +python modules are installed. If you installed Open vSwitch python +modules via the debian package of 'python-openvswitch' or via pip by +running 'pip install python-openvswitch', you do not need to specify the +path. If you installed it by following the instructions in INSTALL.md, you +should specify the path. The path in that case depends on the options passed +to ./configure. (It is usually either '/usr/share/openvswitch/python' or +'/usr/local/share/openvswitch/python'.) + [INSTALL.md]: INSTALL.md [openvswitch-switch.README.Debian]: debian/openvswitch-switch.README.Debian [README.RHEL]: rhel/README.RHEL -- 1.9.1 _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev
