On 9/23/15 09:35, Jesse Gross wrote: > On Fri, Sep 18, 2015 at 7:30 PM, 渔舟 <yuz...@mogujie.com> wrote: >> Hi, all >> Communication failed happened sometimes (about fifty-fifty) with combination >> of ovs >> and linux native bonding( 802.3ad mode), but if I use ovs own >> bonding(lacp=active) instead, >> the failure disappeared, any ideas? >> >> I read below post, which mentioned that "it may not be possible to use the >> Linux bonding at >> the same time as Open vSwitch for Linux before 2.6.36", but I failed to get >> deeper info about that . >> http://openvswitch.org/pipermail/discuss/2010-September/004407.html > That post was referring to a different mode of bonding other than LACP > (which did not exist in OVS at the time). The type of issues referred > there should not affect LACP so I don't think there is an inherent > problem. > > What is the issue? > Network disconnection happened sometimes after reboot the host. The network configuration was right by ethtool, cat /proc/net/bonding/bond0, ifconfig, route, and /etc/sysconfig/network-scripts.
And, one clue is that the hardware switch's ports status were pause when the network disconnection happened. But after I use ovs own bonding(lacp = active) instead, the disconnection never happened. _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev
