Thanks Mark.. I will this and let you know the status.
On Wed, Jul 1, 2015 at 7:25 PM, Gray, Mark D <mark.d.g...@intel.com> wrote: > > > > I'm not using vhost at present. But using macvtap devices. Below screen > shot > > for your reference and following are the details on host. > > > > > > > > [root@artha utilities]# ifconfig macvtap2 > > macvtap2: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 > > inet6 fe80::5054:ff:fec7:ed4f prefixlen 64 scopeid 0x20<link> > > ether 52:54:00:c7:ed:4f txqueuelen 500 (Ethernet) > > RX packets 272 bytes 17248 (16.8 KiB) > > RX errors 0 dropped 0 overruns 0 frame 0 > > TX packets 12 bytes 898 (898.0 B) > > TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 > > > > [root@artha utilities]# ifconfig pktovs > > pktovs: flags=323<UP,BROADCAST,RUNNING,PROMISC> mtu 1500 > > inet 10.54.218.81 netmask 255.255.255.0 broadcast 10.54.218.255 > > inet6 fe80::e611:5bff:fe98:993 prefixlen 64 scopeid 0x20<link> > > ether e4:11:5b:98:09:93 txqueuelen 500 (Ethernet) > > RX packets 224 bytes 14562 (14.2 KiB) > > RX errors 0 dropped 131 overruns 0 frame 0 > > TX packets 39 bytes 2894 (2.8 KiB) > > TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 > > > > I created vhost-user ports using following cmds. > > > > ./ovs-vsctl --no-wait add-br pktovs -- set Bridge pktovs > > datapath_type=netdev ./ovs-vsctl add-port pktovs dpdk1 -- set Interface > > dpdk1 type=dpdk ./ovs-vsctl add-port pktovs dpdkvhost1 -- set Interface > > dpdkvhost1 type=dpdkvhostuser > > > The gui might not have those options you would need to use the qemu > command line. > > This file has loads of instructions and the section in the link below shows > the changes needed to the Qemu command line > > > https://github.com/openvswitch/ovs/blob/master/INSTALL.DPDK.md#dpdk-vhost-user-vm-configuration > -- Thanks & Regds ------------------------------------------------ Varun Rapelly, 9620637186 _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev
