On Mon, Nov 10, 2014 at 4:00 AM, Lori Jakab <loja...@cisco.com> wrote:
>
> On 11/7/14 8:50 AM, Pravin Shelar wrote:
>>
>> On Thu, Nov 6, 2014 at 12:21 PM, Lori Jakab <loja...@cisco.com> wrote:
>>>
>>> On 11/6/14 4:06 AM, Pravin Shelar wrote:
>>>>>>
>>>>>> Have you tried running GSO traffic over lisp using OVS compat GSO code
>>>>>> and upstream GSO code?
>>>>>
>>>>>
>>>>> I haven't and I'm not sure what's the right way to do that.  I do my
>>>>> testing
>>>>> between to VMs.  I see with ethtool that GSO is enabled on the virtual
>>>>> NICs
>>>>> in the VMs, and on the br0 interface after the switch is created.
>>>>>
>>>> This is fine.
>>>>
>>>>> To test that I can enable/disable GSO I download a 30MB file over HTTP
>>>>> and
>>>>> look in Wireshark for packets satisfying "ip.len > 1500".  With TSO
>>>>> enabled,
>>>>> I do get such packets.  Not with GSO though.
>>>>>
>>>>> Can you point me to the right way to test this?
>>>>
>>>> netperf test will to the trick, But you need to test with different
>>>> kernel versions.
>>>> - kernel < 3.10 where ovs configure could not find symbol
>>>> "gre_handle_offloads"
>>>> - kernel 3.17 which has all the offload used by OVS.
>>>
>>>
>>> I have one VM with Fedora 18 and kernel 3.7.2-201.fc18.x86_64, and the
>>> other
>>> with Fedora 19 and kernel 3.14.19-100.fc19.x86_64.  I tried netperf in
>>> both
>>> directions.  In both cases the OVS + LISP performance vs. direct link
>>> performace was one order of magnitude worse.  Is that to be expected?  Is
>>> this a good enough test for GSO traffic?  If yes, I will send out v7.
>>>
>> Can you give me numbers the you are seeing? One way to test GSO is to
>> look for any dropped packet at source, tcpdump can help with that. You
>> also need to set physical MTU large enough for encapsulated packet.
>
>
> I found packet loss unrelated to GSO, I need to add layer 3 support to
> ovs_packet_cmd_execute() as well.  I'll get back to you after I finish this
> and I'm able to do the tests.
>

ok.

What are you plans regarding L3 GRE support? We need it to upstream this work.

Thanks,
Pravin.
_______________________________________________
dev mailing list
dev@openvswitch.org
http://openvswitch.org/mailman/listinfo/dev

Reply via email to