Ben,
 Looks mostly good (and a helpful improvement on the prior documentation). One 
small error:

+       and the rate at which it is willing to transmit them.  Open vSwitch
        uses a detection multiplier of three, meaning that an endpoint
+       signals a connectivity fault if it fails to receive BFD consecutive
+       control messages at the expected rate.

I think that should be "...three consecutive BFD control messages…"

Same error occurs again in 
        <column name="bfd" key="forwarding_if_rx" type='{"type": "boolean"}'>

+          True to consider the interface capable of packet I/O as long as it
+          continues to receive any packets (not just BFD packets).  This
+          prevents link congestion that causes BFD consecutive control packets
+          to be lost from marking the interface down.

Same fix: should be "...three consecutive BFD control messages…"

And 3 typos:

In      <column name="bfd" key="check_tnl_key" type='{"type": "boolean"}'>

+          Set to true to make BFD accept only control messages with an tunnel
"an" -> "a"

In      <column name="bfd" key="bfd_dst_mac">

+         to set the MAC used as destination for transmitted BFD packet and
"packet" -> "packets"

In      <column name="bfd_status" key="remote_diagnostic">

+         In case of a problem, set to a short message that reports what the
+         remote endpoint's BFD session thinks is wrong

Looks like a missing period.

Would you like to update my vtep.xml patch with these improvements?

Bruce




On Oct 24, 2013, at 9:57 AM, Ben Pfaff wrote:

> On Thu, Oct 24, 2013 at 09:53:19AM -0700, Ben Pfaff wrote:
>> On Thu, Oct 24, 2013 at 08:30:51AM -0700, Bruce Davie wrote:
>>> A number of new key-value pairs have been added to the bfd and bfd_status
>>> columns of the OVS schema since the VTEP schema was created. To aid
>>> interoperability between OVS instances and VTEPs, this patch brings
>>> the VTEP schema into line with that of OVS.
>>> 
>>> Signed-off-by: Bruce Davie <bda...@vmware.com>
>> 
>> I sent out a patch a few minutes ago to update the BFD documentation,
>> which much of this patch is based upon.  My patch is at:
>>        http://openvswitch.org/pipermail/dev/2013-October/033238.html
> 
> It may be easier to read with spaces-only changes omitted:
>        http://openvswitch.org/pipermail/dev/2013-October/033240.html

_______________________________________________
dev mailing list
dev@openvswitch.org
http://openvswitch.org/mailman/listinfo/dev

Reply via email to