Fixed, thanks.

On Thu, Mar 21, 2013 at 03:42:23PM -0700, Reid Price wrote:
> One nit, there is only one line between the 'Bonds' section and 'Controllers'
> section.  Everywhere else in the file you use 2 lines, with the (accidental)
> exception of between 'General' and 'Releases', which has 3.
> 
>   -Reid
> 
> On Thu, Mar 21, 2013 at 3:22 PM, Ben Pfaff <b...@nicira.com> wrote:
> > CC: Jesse Gross <je...@nicira.com>
> > Signed-off-by: Ben Pfaff <b...@nicira.com>
> > ---
> >  FAQ |   29 +++++++++++++++++++++++++++++
> >  1 file changed, 29 insertions(+)
> >
> > diff --git a/FAQ b/FAQ
> > index 1a2c4f8..90d0003 100644
> > --- a/FAQ
> > +++ b/FAQ
> > @@ -765,6 +765,35 @@ A: Do you have a controller configured on br0 (as the 
> > commands above
> >     can refer to the answer there for more information.
> >
> >
> > +Bonds
> > +-----
> > +
> > +Q: Can I use Linux bond devices on Open vSwitch bridges?
> > +
> > +A: Yes.  If you are already accustomed to configuring and using Linux
> > +   bond devices, then you can continue to use them with Open vSwitch.
> > +   You can add a Linux bond device to an Open vSwitch bridge with
> > +   "ovs-vsctl add-port", the same way as with other network devices.
> > +
> > +   You should not configure an IP address on a Linux bond device that
> > +   you add to an Open vSwitch bridge.  See the "Configuration
> > +   Problems" section for more information.
> > +
> > +   Linux bonds may have reduced performance compared to Open vSwitch
> > +   bonds, because Open vSwitch lacks the direct visibility into the
> > +   attached interfaces that would allow it take advantage of NIC
> > +   offload features.
> > +
> > +   Linux bonds and Open vSwitch bonds have different features.  Linux
> > +   bonds don't, for example, offer the SLB balancing mode, and cannot
> > +   because the bond device does not have access to the Open vSwitch
> > +   MAC table.
> > +
> > +Q: It looks like each of the interfaces in my bonded port shows up
> > +   as an individual OpenFlow port.  Is that right?
> > +
> > +A: See the "Controllers" section below.
> > +
> >  Controllers
> >  -----------
> >
> > --
> > 1.7.10.4
> >
> > _______________________________________________
> > dev mailing list
> > dev@openvswitch.org
> > http://openvswitch.org/mailman/listinfo/dev
_______________________________________________
dev mailing list
dev@openvswitch.org
http://openvswitch.org/mailman/listinfo/dev

Reply via email to