The "service force-reload-kmod" command did not work properly, if there
was a bridge, which name was a prefix of string "broadcast" (e.g. "br").
To reproduce:
ovs-vsctl add-br br
service openvswitch-switch force-reload-kmod
This patch will make sure that the generated ip commands are clearly
interpretable by the ip utility.
Issue #9841
Signed-off-by: Ansis Atteka <aatt...@nicira.com>
---
utilities/ovs-save | 8 ++++----
1 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/utilities/ovs-save b/utilities/ovs-save
index 323d184..de31290 100755
--- a/utilities/ovs-save
+++ b/utilities/ovs-save
@@ -54,7 +54,7 @@ fi
devs=$*
for dev in $devs; do
- state=`ip link show $dev` || continue
+ state=`ip link show dev $dev` || continue
echo "# $dev"
# Link state (Ethernet addresses, up/down, ...)
@@ -83,12 +83,12 @@ for dev in $devs; do
linkcmd="$linkcmd mtu $mtu"
fi
if test -n "$linkcmd"; then
- echo ip link set $dev down # Required to change hwaddr.
- echo ip link set $dev $linkcmd
+ echo ip link set dev $dev down # Required to change hwaddr.
+ echo ip link set dev $dev $linkcmd
fi
# IP addresses (including IPv6).
- echo "ip addr flush $dev 2>/dev/null" # Suppresses "Nothing to flush".
+ echo "ip addr flush dev $dev 2>/dev/null" # Suppresses "Nothing to flush".
ip addr show dev $dev | while read addr; do
set -- $addr
--
1.7.9.1
_______________________________________________
dev mailing list
dev@openvswitch.org
http://openvswitch.org/mailman/listinfo/dev
