No, it is the same board and config that worked before with NuttX 8.2 without such issues. Only several modifications same as was done for fmu-v5 to work with 10.0.0. Serial consoles on PX4 boards work ok, no such issues, right?
ср, 11 нояб. 2020 г. в 14:14, David Sidrane <david.sidr...@nscdg.com>: > Are you running any PX4IO drivers or RC input? > > -----Original Message----- > From: Oleg Evseev [mailto:ev.m...@gmail.com] > Sent: Wednesday, November 11, 2020 3:09 AM > To: dev@nuttx.apache.org > Subject: Serial console strange behaviour > > Hi, > > Custom board stm32f7, PX4 based project - moved from NuttX 8.2 to 10.0.0. > If serial dev console (CONFIG_USART6_SERIAL_CONSOLE=y) is used, it works: > prints all corresponding output on boot, but then > > "nsh> " is shown only when I start typing in putty. > "ls" command shows only the first output line. Other lines are shown only > if I type at least one symbol. > I tried with and without CONFIG_USART6_RXDMA - same result. > > USB CDC ACM console works OK. > > Any thoughts on what can cause such behavior? > > --- > With best regards, Oleg >
