From: Hyong Youb Kim <[email protected]>
For non-UDP/TCP packets, enic may wrongly set PKT_RX_L4_CKSUM_BAD in
ol_flags. The comparison that checks if a packet is UDP or TCP assumes
that RTE_PTYPE_L4 values are bit flags, but they are not. For example,
the following evaluates to true because NONFRAG is 0x600 and UDP is
0x200, and causes the current code to think the packet is UDP.
!!(RTE_PTYPE_L4_NONFRAG & RTE_PTYPE_L4_UDP)
So, fix this by comparing the packet type against UDP and TCP
individually.
Fixes: 453d15059b58 ("net/enic: use new Rx checksum flags")
Cc: [email protected]
Signed-off-by: Hyong Youb Kim <[email protected]>
Reviewed-by: John Daley <[email protected]>
---
drivers/net/enic/enic_rxtx.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/net/enic/enic_rxtx.c b/drivers/net/enic/enic_rxtx.c
index a3663d516..831c90a1c 100644
--- a/drivers/net/enic/enic_rxtx.c
+++ b/drivers/net/enic/enic_rxtx.c
@@ -285,7 +285,8 @@ enic_cq_rx_to_pkt_flags(struct cq_desc *cqd, struct
rte_mbuf *mbuf)
else
pkt_flags |= PKT_RX_IP_CKSUM_BAD;
- if (l4_flags & (RTE_PTYPE_L4_UDP | RTE_PTYPE_L4_TCP)) {
+ if (l4_flags == RTE_PTYPE_L4_UDP ||
+ l4_flags == RTE_PTYPE_L4_TCP) {
if (enic_cq_rx_desc_tcp_udp_csum_ok(cqrd))
pkt_flags |= PKT_RX_L4_CKSUM_GOOD;
else
--
2.12.0
